Mixing mortar for your gardening projects

Mixing mortar for your garden projects

This article is aiming to show you how you can mix small amounts of mortar without a cement mixer.

Step One 
Most mortar ranges from 6 to 1 (6 parts sand to 1 part cement) for brick/block/slab laying or a stronger mix of 4 to 1 which is can be used for pond linings and areas that are constantly wet. Mortar is best mixed on a hard surface, ideally a wooden board covered with a strong plastic sheet. Firstly using a bucket to measure out the sand i.e 6 parts, then the cement i.e 1 part and mix together until the whole mix has a even colour. The advantage of mixing on a plastic sheet is that it is easy to keeping the mixture together.

Step Two
Fill a bucket with some water and add a few drops of washing up liquid which will act as a plasterser. This helps to create bubbles in the mortar making it easier to use as you adjust the levels off the bricks or paving on the mortar bed. Other additives which can be used are a waterproofer for a pond or waterfall, dries that create a range of colours, and additives that stop the mortar freezing in the winter.

Step Three
Once the mortar has been mixed in the dry form you should create a mound with a hollow centre and add a small amount of water. Next working from the outside start to turn the mix into the middle so that the water is soaked up. Then mix throughly and repeat until the mortar is starting to look as it does in the final photo.

Step Four
The amount of wateradded to the mix will largely depend on the job you are undertaking, but in general it should on the dry side allowing you to add more water if needed. A mix should last for about 30 minutes to a hour depending on the air temperature. Once used mortar normally takes about 3 days to set in full, the slower it dries within reason the stronger it wil be, for this reason if is often a good idea to cover the new brick work or patio with a sheet for a day or two after construction in the hottest part of summer.

Finally if you find yourself using mortar in the winter it will need to be covered overnight in frosty weather to protect from freezing.